Cal.D710 Setting Instruction : Scuba Diving Log Mode

Mode Change Flow

Using the Scuba Diving Log Mode

The scuba diving log mode is used to display the scuba diving log automatically recorded by the watch during scuba diving. A maximum of 100 sets of log data can be recorded for scuba diving (provided that the dive time of a single dive is within 2 hours and no more than 15 dives per day). The contents of log data for a single dive are displayed using three displays for both the scuba diving log and skin diving log modes.

Calling Up Scuba Diving Log Data

1.	The most recent scuba diving log data is displayed when the watch is switched to the scuba diving log mode by pressing the lower left button (D).
2.	The log data that you want to view can be selected by pressing either the lower right button (A) or upper right button (B). Logs are identified according to the number of the dive (No.) among the total number of dives.
2.	* Old log data is called up each time the lower right button (A) is pressed once, while new log data is called up each time the upper right button (B) is pressed once. (Pressing either button continuously causes the log data to change rapidly.)
3.	The display of the selected log data changes each time the upper left button (C) is pressed once.

*	The dive condition mark displayed on a first display represents the dive condition for that dive.
*	The oxygen concentration set before diving on the first display is displayed for the log data during NITROX diving.
*	"DECO" is displayed on the second display in the case decompression diving has occurred during diving.
*	"NO LOG" is displayed when there is no log data stored in the watch.
*	"--.- m" is displayed for maximum depth when the maximum depth during diving has exceeded 80.0 m (266 ft).
*	The average depth flashes when an error has occurred in water depth measurement while diving.
*	The minimum water temperature flashes when the water temperature has exceeded the water temperature measuring range while diving.
*	Reference values for dive time, time out, maximum depth, average depth and minimum water temperature are displayed flashing while recording of log data is interrupted during diving due to the watch becoming insufficient charged.
*	Slightly more time may be required to call up log data when there is a large amount of log data stored in the watch. In such cases, "WAIT" is displayed while the log data is being called up. The water sensor and all buttons do not function while "WAIT" is being displayed.

Deleting Log Data

Individual sets of log data cannot be deleted. When a new dive is made when there are already 100 sets of dive data recorded for the total dive data of scuba diving log data and skin diving log data, the oldest log data is automatically deleted.

It is strongly recommended to promptly record important log data in another storage medium. When a new dive is made and there are already 100 sets of dive data recorded for the total dive data of scuba diving log data and skin diving log data, the oldest log data is automatically deleted. In addition, since there is also the possibility of data being lost due to a malfunction in the watch or during repairs or inspections, it is recommended to promptly transfer data to a personal computer following completion of diving. Please note that the manufacturer cannot be responsible for data that is lost due to a malfunction.

To Page-Top