Mode Change Flow
 Using the Standard Mode : Using the Timer Mode
The timer of this watch can be set up to 99 minutes in 1 minute units. An alarm sound indicating that the time is up sounds for about 30 seconds and "Timer" is displayed on the display when the time on the timer is up. The timer then returns to the initial set time and stops. In addition, the alarm sound indicating that time is up following completion of timing can be selected from 15 types of alarm sounds.

A. Setting the Timer
1. The minutes flash when the upper left button (C) is pressed for at least 2 seconds and then released in the timer mode.
2. Set the minutes by pressing the upper right button (B) or lower right button (A).
. Pressing the upper right button (B) advances the display by one minute at a time each time it is pressed while pressing the lower right button (A) moves back the display by one minute at a time each time it is pressed. (Pressing either button continuously causes the display to change rapidly.)
3. The time up alarm number flashes each time the upper left button (C) is pressed.
4. Set the time up alarm number by pressing the upper right button (B) or lower right button (A).
* Pressing the upper right button (B) once calls up the next time up alarm number each time it is pressed, while pressing the lower right button (A) once calls up the next time up alarm number in the reverse order each time it is pressed. Select "Silent" when you do not want the time up alarm to sound.
* You can monitor the time up alarm of the number that is flashing by pressing the upper right button (B) or lower right button (A) for as long as the button is pressed. (The next or previous time up alarm number is momentarily displayed the instant the button is pressed, while pressing either button continuously causes the set time up alarm to sound.)
5. Press and release the lower left button (D) and then releasing returns the watch to the timer setting display.






* The watch automatically returns to the timer setting display when none of the buttons are pressed for about 3 minutes in the correction state (display flashing).
* The watch can be immediately returned to the timer setting display by pressing the lower left button (D) and then releasing in the correction state (display flashing).

B. Timer Measuring Procedure
1. The timer is repeatedly started and stopped each time the upper right button (B) is pressed once.
2. The watch returns to the setting display when the upper left button (C) is pressed while the timer is stopped.
* The alarm that sounds when the time is up can be turned off by pressing any buttons.
* Only "Timer" appears on the display to indicate that the time is up when the time up alarm has been set to "Silent".
* The watch automatically returns to the time mode after about 3 minutes have passed during the timer setting display.
* The watch returns to the surface mode when none of the buttons have been pressed for about 3 minutes in the timer mode (including during timing) when the surface mode has been activated (while resting on the surface).
* If the mode is switched to the dive mode, infrared communication mode or low power mode during timing, timing is interrupted and the watch returns to the setting display.
<Repeating Measurement>
The timer is instantly returned to the setting display and resumes timing when the upper left button (C) is pressed once during timer measurement.


To Page-Top

Copyright 2003 CITIZEN WATCH CO.,LTD. ALL Rights Reserved.