Select Functions Names of Components/Switching the Mode Standard Mode : Time Mode Standard Mode : Traveltime Mode Standard Mode : Destination timer Mode Standard Mode : Alarm Mode Standard Mode : Chronograph Mode Standard Mode : Timer Mode Standard Mode : System monitor Mode Dive Plan Mode Scuba Log Mode Skin Log Mode Diving Mode Surface Mode Low power Mode Data Communication Functions

Mode Change flow

Using the Standard Mode : Using the Alarm Mode

Once this alarm is set (ON), the alarm sounds for approximetely 30 seconds at the same time every day and "Alarm" is displayed on the display. The alarm can be turned off by pressing any button when it is sounding. In addition, the alarm tone can be selected from 15 types of alarm sounds when setting the alarm.

A. Alarm ON/OFF and Alarm Monitor

*	The alarm is switched between ON (set) and OFF (canceled) each time the upper right button (B) is pressed once in the alarm mode.
*	Once the alarm has been set, the alarm ON mark is displayed in the time mode. When the upper right button (B) is pressed continuously in the alarm mode, you can monitor the selected alarm tone for as long as the upper right button (B) is pressed.

B. Setting the Alarm

1.	The watch switches to the correction state (display flashes) when the upper left button (C) is pressed for at least 2 seconds and then released during then the normal display in the alarm mode. The flashing item can be corrected.
2.	The flashing item changes in the order shown below each time the upper left button (C) is pressed once. . Pressing the upper left button (C) and then releasing in the alarm number correction state returns the watch to the normal display.
3.	The flashing item can be corrected by pressing either the upper right button (B) or lower right button (A).
	* Pressing the upper right button (B) once advances the display by one step at a time each time it is pressed, while pressing the lower right button (A) once moves the display back by one step at a time each time it is pressed. (Pressing either button continuously causes the display to change rapidly.) * When the upper right button (B) is pressed once while in the alarm number selection state (an alarm number is flashing), the next alarm number is called up each time it is pressed. When the lower right button (A) is pressed once in the alarm number selection state, the next alarm number is called up in the reverse order each time it is pressed. Select "Silent" when you do not want the alarm to sound. In this case, the alarm time is notified only with "Alarm" on the display. * You can monitor the alarm corresponding to the flashing alarm number by pressing the upper right button (B) or lower right button (A) in the alarm number selection state for as long as the button is pressed. The next or previous alarm number is momentarily displayed the instant the button is pressed, while pressing either button continuously causes the set alarm to sound.
4.	Press and release the lower left button (D) and then releasing finalizes the alarm setting.

* The 12 hour or 24 hour format setting is in accordance with the setting in the time mode. * The watch automatically returns to the normal alarm display when none of the buttons are pressed for about 3 minutes in the correction state (display flashing). * The watch can be immediately returned to the normal alarm display by pressing the lower left button (D) and then releasing in the correction state (display flashing). * The watch automatically returns to the time mode when none of the buttons are pressed for about 3 minutes during the normal alarm display.

---

To Page-Top

Copyright 2003 CITIZEN WATCH CO.,LTD. ALL Rights Reserved.