Model : Promaster CYBER AQUALAND Nx
   Names of Components   Display Mode
Standard Mode
 The watch is usually used in this mode. The standard mode consists of the following seven modes.
1. Time Mode
2. Travel Time Mode
3. Destination Timer Mode
4. Alarm Mode
5. Chronograph Mode
6. Timer Mode
7. System Monitor Mode /
Dive Plan Mode
Scuba diving log Mode
Skin diving log Mode
Dive Mode
Surface Mode
Infrared Communication Mode
Low power mode
(Temporary     function)
Do not wear the watch in the low power mode during daily use. Although the watch can be manually switched to this mode by operating the buttons, all functions except for time and date display and correction do not operate. In addition, the watch cannot be switched from the low power mode to the dive mode.

 Before Using
. Please make sure to adequately charge the watch using the charger provided.
. Charger.
. Charge Level Indicator and Continuous Usage Time.
. Location Displayed by this Watch.
. Safety Precautions: Observe at All Times.
. Diving Terms Used by this Watch

Problem Possible Cause Corrective Action Reference : Click here.

Switching the Mode
. The mode of the standard mode changes in the order of time, travel time, destination timer, alarm, chronograph, timer and system monitor each time the lower right button (A) is pressed in the standard mode.
. The mode changes in the order of standard mode, dive plan mode, scuba diving log mode, skin diving log mode and surface mode each time the lower left button (D) is pressed.
. The watch automatically switches to the dive mode (preliminary dive display) when the water sensor gets wet in any mode (excluding the infrared communication mode and low power mode).
. The watch switches to the infrared communication mode (initial display) when the lower left button (D) is pressed for at least 2 seconds and then released in any mode (excluding the dive mode and low power mode).

* The surface mode is no longer displayed once measurement of no fly time (timer) is completed after scuba diving. The watch switches to the time mode of the standard mode when the lower left button (D) is pressed in the skin diving log mode when the surface mode is not activated.
* When none of the buttons are pressed for about 3 minutes in any of the modes of the standard mode, dive plan mode, scuba diving log mode or skin diving log mode, the watch automatically returns to the time mode of the standard mode (except that it returns to the surface mode when the surface mode has been activated).
* The watch switches to the low power mode when the lower right button (A) and lower left button (D) are pressed for at least 2 seconds and then released in the time mode of the standard mode.
* If "BATT", "ERR" or "CHK" is flashing in the lower left section of the display in any of the modes (indicating that a warning function has been activated), and during correction in any mode, the watch does not switch to the dive mode even if the water sensor gets wet.
* The hourglass mark or "LOADING" are displayed when switching to and from the dive mode, infrared communication mode or low power mode. The water sensor along with all button operations do not function while these are displayed.


Using the EL Light


The EL light is illuminated for about 1 second when the EL light button on the front of the watch is pressed in any of themodes except for the infrared communication mode.
The EL light is illuminated for about 5 seconds when the EL light button is pressed continuously.



   To Page Top


Copyright 2003 CITIZEN WATCH CO.,LTD. ALL Rights Reserved.