Before Using

Please make sure to adequately charge the watch using the charger provided.
This watch is rechargeable. In addition, the watch display has been turned off prior to shipment from the factory in order to reduce power consumption by the energy storage cell of the watch.
* Remove the display seal affixed to the watch display before using the watch.
Before using, fully charge the watch by following the procedure described below. The display can then be illuminated by performing the all-reset procedure.
*Refer to the section entitled, "Charger", for details on the procedure for installing the 4 pcs of size AA alkaline batteries and the procedure for charging the watch.
 (1)  Install 4 pcs. of size AA alkaline batteries in the charger provided.
 (2) Place the watch in the charger and charge the watch until the LED on top of the charger goes out. (It takes about 7 hours to fully charge the watch.)
* We advise recharging to be done at stable flat surface to avoid unexpected disengagement of the watch.
 (3) When the lower right button (A), upper right button (B), upper left button (C) and lower left button (D) are pressed simultaneously and released, an alarm tone sounds after "INITIALIZE" is displayed and the entire display is illuminated (all-reset).
 (4) When any one of the buttons is pressed and released, the time and date are displayed after "LOADING" is displayed.
 (5) Correctly set the time, date and each mode.


Copyright 2003 CITIZEN WATCH CO.,LTD. ALL Rights Reserved.